VMP 2015-17 Coyote Mustang Main SC kit box w/lower intake

Please select fitment

VMP 2015-17 Coyote Mustang Main SC kit box w/lower intake

SKU: VMP-15-6006-AA-kit

VMP 2015-17 Coyote Mustang Main SC Kit Box w/Lower Intake

An essential part of the VMP Performance TVS supercharger kit for 2015+ Coyote powered Mustangs. These items are included by default when purchasing a complete kit. This item is available for purchase and intended to be used by individuals piecing a kit together over time or who are missing key parts on a second hand kit.

This is only available as a complete purchase and will not be separated or parted out.

Included in Main SC kit box with lower intake, are the following necessary items:

Fuel Charging Assembly (lower intake manifold, assembled)
Upper FEAD Bracket
FEAD Tensioner œSpider Bracket Assembly
Intercooler Degas Bottle/Reservoir
Intercooler Electric Water Pump with Bracket
3/4" œL Hose “ Degas Bottle Inlet “ Top of lower intk to Degas
3/4" Long Hose “ Intercooler LTR Outlet “ Bottom lower intk to HE
3/8" Hose “ engine degas bottle to engine
PCV Fresh Air Inlet - hard molded U-tube
PCV Purge Hose - hard molded with rubber bubbler hose
Beavis Extension Hose
Vacuum line molded “ SC Bypass Vent ref top of BPV to side of CAI

Hardware Kit B “ Fuel Charging (inside main box)
Gasket Red “ Throttle Body To Gen2 Blower
Bolt “ Throttle Body to Spacer & Supercharger (M6 x 32.5)(4 used)
Bolt “ Intake to Cylinder Heads (M6 x 40)
Bolt “ Supercharger to Intake (M8 x 53) (one not used with gen2)

Hardware Kit C “ FEAD (inside main box)
Pulley - Idler B/S 76mm (for 6-rib only, 8-rib gets upgraded)
Bolt “ Idler (M8 x 28 large washer)
Bolt “ Upper FEAD to Engine and Intake (M8 x 84)
Bolt “ Lower Bracket to Upper Bracket (M8 x 41)
Bolt “ Lower Bracket to Engine (M8 x 120)

Hardware Kit E “ VMP I/C system (inside main box)
Degas Bottle Cap
Clamps “ ¾ Hoses (Constant Tension)
Degas Bottle TO Fan Shroud retaining clip
J-Clip “ Degas Bottle (M8 Short)
Bolt “ Degas Bottle Mounting
J-Clip “ Degas Bottle 2nd mounting point (use M6 bolt)

Misc Parts Baggy (inside main box)
Grommet “ Induction Resonance Tube Delete
Decal “ 2011+ Belt Routing Diagram
3/16 ID Vacuum Hose - 6/150mm
3/4 Hose Sleeve “ 424mm Heater Hoses (optional)

No reviews available

Be the first to Write a Review