• Easy installation
• Constructed of black hardcoat anodized Billet aluminum
• Heavy-duty bearing
• Factory bolt is reused
• Installation Instructions

A great upgrade to the factory idler pulley, the VMP 90 mm idler pulley uses a factory size and brand NSK heavy-duty bearing. When the proper sized bearing is used, the need for double bearings is eliminated.

Easy to install, the VMP 90 mm idler pulley can be installed in just a few minutes in your garage. Made in the USA, with durability in mind, our 90 mm idler pulley is constructed of Billet anodized aluminum.

Fits these applications/situations:

• 2011+ 5.0 L Mustang GT with Roush, Whipple, and VMP Superchargers (some filing may be needed due to core shift in the bracket for the idlers)
• Other applications that require an idler with 17 mm bore
• Can be used with 2.4", 2.5", 2.6", 2.7", or 2.8" supercharger pulleys on a 2007-2012 Shelby GT500. This idler helps eliminate belt slack and gets better wrap with smaller supercharger pulleys
• Roush M90 and P51 TVS blowers when installing a smaller supercharger pulley, install below the supercharger pulley

Note: On a GT500 the idler pulley should be installed below the intercooler tubes, to the left side of the blower.