Home > VMP TVS & Power Adders > VMP TVS Superchargers >

VMP GEN II-R 2.3L TVS for '11-'17 GT 5.0L & Boss 302. STAGE 1-Tuner Kit
VMP GEN II-R 2.3L TVS for '11-'16 GT 5.0L & Boss 302

Alternative Views:

Suggested Retail Price: $6,299.00

Product Code:

Vin Number*:


Serial number of your Tuning device*:

Computer Code/Strategy/Part Number*:

Gear ratio*:

Transmission *:

Tune octane*:

Add Tuner with Custom Tune*:

Pick your Boost*:

You asked for it and VMP Tuning and Superchargers delivers! The pinnacle of TVS technology is now the foundation of power for your '11+ 5.0L Mustang!

2.3L TVS for '11+ GT 5.0L & Boss 302. STAGE 1 is perfect for the budget conscious enthusiast who still wants all the power and ability to upgrade as time goes on. Your kit comes with everything you need, including a non-fanned heat exchanger, now with even larger 56# fuel injectors, a JLT 123mm or Roush cold air and much more.

Just add your own tuning or choose our track and street proven VMP Custom Calibrations and you're ready to roll.

In the Kit
  • VMP Non-Fanned Heat Exchanger with Plug N Play Harness: Dimensions: 2" Thick x 28" Wide x 9.5" Height
  • 56LB Injectors
  • JLT 123mm Plastic CAI for Supercharged(11-14) 5.0L OR Roush 110mm Cold Air Intake for 15+
  • Dual 60MM Throttle Body
  • Your choice of pulley size (see below)
  • Plug and play wiring harness extensions
  • Upper and lower aluminum intake manifolds with high-efficiency intercooler
  • Intercooler pump & lines
  • 1st shiv HD belt system with tensioner, belt, and idlers.
  • All required fasteners, wiring, brackets, hoses and clamps
  • SCT X4 handheld tuning device and VMP Custom Calibration by Justin Starkey (Optional)

  • Performance 600+ RWHP 5.0L and 800+ RWHP Boss 302
  • Reliability 1 year warranty and 100,000 Mile Service Interval on TVS blower
  • Flexibility Dial in at a level appropriate for you with our selection of pulleys & upgrades
  • Driveability Fantastic driveability even at the highest boost levels.
  • Expandability - TONS of room to grow with many of our optional upgrades
Available Pulley Sizes
  • 85mm - 9psi
  • 82mm 10psi
  • 79mm 11-12psi
  • 75mm 13psi
  • 72mm 14psi - (72# Injectors minimum requirement at this level)
  • 69mm 15psi - (72# Injectors minimum requirement at this level)
  • 63mm - 17psi - (8-rib conversion required)
  • 5% and 15% OD crank pulleys available with 8-rib conversion, each 5% adds 1psi

Stage 1 Stage 2 Stage 3
Tuning icon icon icon
Tuner Included icon icon icon
Supercharger VMP GEN II-R 2.3L TVS Supercharger VMP GEN II-R 2.3L TVS Supercharger VMP GEN II-R 2.3L TVS Supercharger
Lower Intake icon icon icon
PulleyYour choice 69mm-85mm Your choice 69mm-85mm Your choice 69mm-85mm
All Necessary Installation Hardware icon icon icon
Throttle Body Twin 60mm Throttle Body Twin 60mm Throttle Body VMP Twin Jet 67mm Throttle Body
Fuel Pump Booster icon icon icon
Injectors 56LB Injectors 56LB Injectors Deatschwerks 95#/1000cc Injectors

Heat Exchanger Non-Fanned Heat Exchanger VMP Triple Pass Heat Exchanger VMP Triple Pass Heat Exchanger
Plug and Play Harness icon icon icon
Installation Instructions icon icon icon
HP Rating 700HP 750HP 800-1000HP

Results for Stage 2 Kit Install and Dyno Tune
Results: VMP 2015 Mustang GT Stage 3 Supercharger Kit 9.9 @ 138 MPH 700rwhp


Important parts and tuning notice:

By ordering this tune, you agree to assume all responsibility for assuring that it is to be used for off-road and/or competition use only and is not to be used on a vehicle that is registered for use on public roads nor highways.

Because U.S., Canadian, and other international, state or provincial laws and regulations may prohibit removal or modification of components that were installed on vehicles by Ford Motor Company to meet emission requirements or to comply with motor vehicle safety regulations applicable to vehicles manufactured for use on public roads, VMP wants you to know the following:

Most of the parts and services offered in this online catalog are for off-road use or competition use only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this off-road or race use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assume all associated risk of the purchase.

Emissions Notice:

Federal and several state and provincial laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. VMP assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customers modifications and/or use of our products or services. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

California Residents

The emissions laws and regulations of the state of California apply to all non-racing vehicles. Consequently, some parts in this catalog may legally be used in California only on a racing vehicle which will never be operated on public roads.