Home > Performance Parts > Replacement Parts & Misc Items >

VMP 2015+ Coyote Mustang ​Main SC kit box w/lower intake
VMP 2015+ Coyote Mustang ​Main SC box


 
Alternative Views:


Suggested Retail Price: $3,000.00

Product Code:
VMP-15-6006-AA
Qty:

Description
 
An essential part of the VMP Performance TVS supercharger kit for 2015+ Coyote powered Mustangs. These items are included by default when purchasing a complete kit. This item is available for purchase and intended to be used by individuals piecing a kit together over time or who are missing key parts on a second hand kit.

This is only available as a complete purchase and will not be separated or parted out.

Included in Main SC kit box with lower intake, are the following necessary items:

Fuel Charging Assembly (lower intake manifold, assembled)
Upper FEAD Bracket
FEAD Tensioner “Spider” Bracket Assembly
Intercooler Degas Bottle/Reservoir
Intercooler Electric Water Pump with Bracket
3/4" “L” Hose – Degas Bottle Inlet – Top of lower intk to Degas
3/4" Long” Hose – Intercooler LTR Outlet – Bottom lower intk to HE
3/8" Hose – engine degas bottle to engine
PCV Fresh Air Inlet - hard molded U-tube
PCV Purge Hose - hard molded with rubber bubbler hose
Beavis Extension Hose
Vacuum line molded – SC Bypass Vent ref top of BPV to side of CAI

Hardware Kit B – Fuel Charging (inside main box)
Gasket Red – Throttle Body To Gen2 Blower
Bolt – Throttle Body to Spacer & Supercharger (M6 x 32.5)(4 used)
Bolt – Intake to Cylinder Heads (M6 x 40)
Bolt – Supercharger to Intake (M8 x 53) (one not used with gen2)

Hardware Kit C – FEAD (inside main box)
Pulley - Idler B/S 76mm (for 6-rib only, 8-rib gets upgraded)
Bolt – Idler (M8 x 28 large washer)
Bolt – Upper FEAD to Engine and Intake (M8 x 84)
Bolt – Lower Bracket to Upper Bracket (M8 x 41)
Bolt – Lower Bracket to Engine (M8 x 120)

Hardware Kit E – VMP I/C system (inside main box)
Degas Bottle Cap
Clamps – ¾” Hoses (Constant Tension)
Degas Bottle TO Fan Shroud retaining clip
J-Clip – Degas Bottle (M8 Short)
Bolt – Degas Bottle Mounting
J-Clip – Degas Bottle 2nd mounting point (use M6 bolt)

Misc Parts Baggy (inside main box)
Grommet – Induction Resonance Tube Delete
Decal – 2011+ Belt Routing Diagram
3/16” ID Vacuum Hose - 6”/150mm
3/4” Hose Sleeve – 424mm Heater Hoses (optional)